Case IH AFX8010 — ENGINE

POWER PRODUCTION - ENGINE Cylinder block - Static description (B.10.A.70 - C.30.A.20) AFX8010 The structure comprises of an engine block, which is attached to a separate base. The seal between the engine block and base is ensured by a layer of sealant. The wet cylinder liners are fitted into the engine block. They are interchangeable and can be removed. Water tightness is assured by rubber washers fitted in the lower part of the cylinder liners. Cylinder liner protrusion can be adjusted using shims, which are available as spares. The main journal seats are machined with both parts of the engine block fitted together.

The inner finish of the cylinder block structure are so well engineered that part deformation is not possible and engine oil consumption is therefore exceptionally low. Liner bores are sorted into two categories; Category A and Category B. A piston of a corresponding category is then matched with each cylinder liner. 20015803 1 20015829 2 9671 1 27/05/2004 B.10.A / 41