Case IH AFX8010 — ENGINE

POWER PRODUCTION - ENGINE 11. Mount the following parts with their gaskets and tightening the screws to the required torque: automatic tightener mount (2) ; and automatic tightener (4) , damper flywheel (3) and the pulley beneath; fixed tightener (6) ; water pump and thermostat assembly (1) ; fan pulley (5) ; pipes with coolant . Refer to Water pump - Torque (B.50.A.20 - D.20.A.10) , Fan and drive - Torque (B.50.A.54 - D.20.A.10) for torque specifications. 50034749A5 11 12. Mount the following, tightening the screws to the required torque: mounts (1) and alternator (2) . Refer to Alternator - Torque (A.30.A.82 - D.20.A.10) for torque information. 20040337 12 13.

With a suitable tool (1) , operate the tightener (2) , in the direction of the arrow and fit the belt (3) . NOTE: The tighteners are automatic, so no further adjustments are required after assembly. 14. Put the tool 380000360 , on the engine fitting hooks, fasten this on the hoist. Remove the screws fixing the brackets: 380000155 , to the rotary stand, lift the engine and disconnect the above-mentioned brackets. Complete the assembly of the engine with the following parts and tighten the fixing screws or nuts to the required torque: fit the drive (1) , then fit the engine mounts. 50034764A5 13 mid0380a 14 9671 1 27/05/2004 B.10.A / 53