POWER PRODUCTION - ENGINE 4. Fit the gear (2) , back on the camshaft, without fully locking the screws (5) , positioning it so that the 4 slots are centered with the camshaft fixing holes. Using a dial gauge with a magnetic base (1) , check the clearance between the gears (2) and (3) : 4.39 - 4.49 mm ( 0.173 - 0.177 in ). If this is not so, adjust the clearance as follows: loosen the screws (4) , fixing the transmission gear (3) , loosen the screw fixing the lever, then move the connecting rod to obtain the required clearance; lock the screw fixing the connecting rod and the screws fixing the transmission gear to the required torque. See Timing gear - Torque (B.10.A.45 - D.20.A.10) .
20043353 4 5. Position the exhaust and intake valve control crosspieces. IMPORTANT: Position the crosspieces on the valve stem, all with the largest hole on the same side. IMPORTANT: Before refitting the rocker arm shaft assembly, make sure that all the adjustment screws have been fully unscrewed. 6. With tool 380000128 (3) , constrain the sliding blocks (4) , to the rocker arms (3) . Apply tool (1) , to the rocker arm shaft (5) 380000148 and position it on the cylinder head. IMPORTANT: Before assembly, the screws (2) , must be lubricated with engine oil. 20043352 5 9671 1 27/05/2004 B.10.A / 60