POWER PRODUCTION - ENGINE Crankshaft - Measure (B.10.A.43 - F.40.A.16) AFX8010 IMPORTANT: Handle all parts carefully. Do not put your hands or fingers between parts. Wear suitable safety clothing - safety goggles, gloves and shoes. 1. Before reinstalling the crankshaft, the main journals and crankpins must be checked for size. Before grinding the pins of the shaft (2) , measure the pins with a micrometer (1) and establish, depending on the level of undersizing of the bearings, what diameter you need to reduce the pins. The classes of undersizing are 0.127 mm - 0.254 mm - 0.508 mm ( 0.0050 in - 0.0100 in - 0.0200 in ).
It is recommended that all measurements are noted in a table for reference. IMPORTANT: All the main journals and crankpins should always be ground to the same class of undersizing so the balance of the crankshaft is not altered. 2. The main data for a crankshaft and main bearing shells are shown in Crankshaft - Dimension (B.10.A.43 - D.40.A.30) . 280820031389310 1 280820031390789 2 9671 1 27/05/2004 B.10.A / 66