POWER PRODUCTION - ENGINE Valve drive - Clearance (B.10.A.40 - F.45.A.12) AFX8010 IMPORTANT: Handle all parts carefully. Do not put your hands or fingers between parts. Wear suitable safety clothing - safety goggles, gloves and shoes. 1. Adjusting the clearance between the rocker arms and the intake and exhaust valve cross-pieces and adjusting the pre-load of the pump injector rocker arms must be done very carefully. Take the cylinder associated with the valves involved in the clearance adjustment into the combustion phase. The valves of this cylinder will be closed while they balance those of the symmetrical cylinder. The symmetrical cylinders are 1 - 6, 2 - 5, and 3 - 4.
To perform these operations correctly, proceed as described below and as shown in the ignition sequence table in Valve drive - General specification (B.10.A.40 - D.40.A.10) . To adjust the clearance between rocker arms and intake and exhaust valve cross-pieces: Loosen the nut locking the adjustment screw (1) . Insert the blade of the feeler gauge (2) . Using a wrench, screw or unscrew the adjustment screw. Check that the blade of the feeler gauge (2) , can slide with a slight amount of friction. Lock the nut (1) , securing the adjustment screw. 20040340 1 9671 1 27/05/2004 B.10.A / 65