POWER PRODUCTION - ENGINE 6. When the slots (1) , are not sufficient to recover the timing, the camshaft turns because it becomes integral with the gear (2) . The reference value of the cam lift changes accordingly and it is necessary to proceed as follows: Make sure the screws securing the camshaft gear are tight. Turn the engine flywheel clockwise by approximately 1/2 turn. Turn the engine flywheel counterclockwise until the dial gauge shows a camshaft cam lift value of: 4.39 - 4.49 mm ( 0.173 - 0.177 in ). Take out the screws attaching the camshaft gear and remove the gear from the camshaft. mid0362a 6 7.
The camshaft timing is correct if the above cam lift values correspond to the following conditions: The hole with a double notch (5) , can be seen through the inspection window; the tool 380000150 (1) , through the seat (2) , of the engine speed sensor, enters the hole (3) , in the engine flywheel (4) . Reinstall the camshaft gear and tighten the fixing screws to the required torque, as noted in Timing gear - Torque (B.10.A.45 - D.20.A.10) . mid3060a 7 8. In the conditions described above, check that the pin 380000151 (2) , is positioned on the marked tooth of the phonic wheel (1) . If this is not so, loosen the screws (3) and orient the phonic wheel (1) , appropriately.
Then tighten the screws (3) , to the required torque, as noted in Timing gear - Torque (B.10.A.45 - D.20.A.10) . mid0363a 8 9671 1 27/05/2004 B.10.A / 64