POWER PRODUCTION - ENGINE 3. Position the dial gauge with a magnetic base (1) , with the rod on the roller (2) , of the rocker arm governing the injector of cylinder No. 1 and pre-load it by approximately 6 mm ( 0.236 in ). Using tool 380000137 , turn the crankshaft clockwise until the pointer of the dial gauge reaches the minimum value under which it cannot go. Zero the dial gauge. Turn the engine flywheel anti-clockwise until on the dial gauge you read the cam lift value of the camshaft of: 4.39 - 4.49 mm ( 0.173 - 0.177 in ). mid0359a 3 4. The camshaft timing is correct if the above cam list values correspond to the following conditions:
The hole with a double notch (5) , can be seen through the inspection window; the tool 380000150 (1) , through the seat (2) , of the engine speed sensor, enters the hole (3) , in the engine flywheel (4) . mid3060a 4 5. If the results noted above were not obtained, proceed by loosening the screws (2) , fixing the gear (1) , to the camshaft (3) . Take appropriate action on the engine flywheel to bring about the conditions indicated in points 1 and 2 above, but the cam lift must not be affected. Lock the screws (2) and repeat the check as described above. Tighten the screws (2) , to the required torque. mid0361a 5 9671 1 27/05/2004 B.10.A / 63