Case IH AFX8010 — ENGINE

POWER PRODUCTION - ENGINE 5. To obtain the required assembly clearances, the main and big end bearing shells need to be selected as described below. This operation makes it possible to identify the most suitable half bearings for each of the pins of the shaft (the half bearings may even be of a different class from one pin to another). Depending on the thickness, the half bearings are selected in classes of tolerance, marked by a color (red/green - red/black - green/black).

The data below gives the characteristics of the main and big end bearing shells available as spares in the standard (STD) sizes and in the permissible oversizes ( 0.127 mm , 0.254 mm , 0.508 mm [ 0.0050 in , 0.0100 in , 0.0200 in ]). 6. For each of the pins of the crankshaft, it is necessary to carry out the following: Main Journals - determine the class of diameter of the seat in the crankcase; determine the class of diameter of the main journal; and choose the class of half bearings to fit. Crankpins - determine the class of diameter of the seat in the connecting rod; determine the class of diameter of the crankpin and choose the class of half bearings to fit.

Selecting Small End Bearings (Pins With Nominal Diameter) - two sets of figures are marked on the front of the crankcase, in the position shown (top section of figure below) a four-digit number represents the coupling number of the crankcase with its respective sub-crankcase; the following seven digits, taken singly, represent the class of diameter of each of the main bearing seats to which they refer (bottom section of figure below), and each of these digits may be 1, 2 or 3. 280820031399055 5 280820031399829 6 9671 1 27/05/2004 B.10.A / 68