POWER PRODUCTION - ENGINE 7. Main journals and crankpins: determining the class of diameter of the pins. Three sets of figures are marked on the crankshaft, in the position shown by the arrow (top of figure shown below): the first number, comprising five digits, is the serial number of the shaft; underneath this number, on the left, a set of six digits refers to the crankpins and is preceded by a single digit, which indicates the status of the pins (1 - STD, 2 = -0.127 [0.0050"]), the other six digits, taken singly, represent the class of diameter of each of the crankshafts to which they refer.
The set of seven digits, on the right side, refers to the main journals and is preceded by a single digit, which indicates the status of the pins (1 - STD, 2 = 0.127 [0.0050]), the other seven digits taken singly, represent the class of diameter of each of the main journals to which they refer (bottom of figure shown below). 280820031400886 7 8. After measuring the essential data for each of the main journals on the crankcase and crankshaft, choose the type of half bearings to use according to the information in the figure below. 280820031402021 8 9671 1 27/05/2004 B.10.A / 69