Case IH AFX8010 — ENGINE

POWER PRODUCTION - ENGINE Connecting rod and piston - Install (B.10.A.47 - F.10.A.15) AFX8010 IMPORTANT: If visual inspection indicates there is no need to replace the connecting rod bearings, it is necessary that they are reinstalled back in the same sequence and position found during disassembly. If you need to replace them, select the connecting rod bearings according to the selection described in Connecting rod and piston - Assemble (B.10.A.47 - F.10.A.20) . 1. Lubricate the half bearings (1) and fit them on the connecting rod (2) and on the cap (4) . IMPORTANT: Do not make any adjustments to the half bearings. mid0331a 1 2.

Lubricate the pistons, piston rings and the inside of the cylinder liners. With the aid of the clamp, (1) , 380000220 , fit the connecting rod-piston assemblies, (2) , in the cylinder liners according to Figure 1 , checking that: the number of each connecting rod corresponds to the cap coupling number; the symbol (2) Figure 3 , punched on the top of the pistons faces towards the engine flywheel; or the cavity in the shell of the pistons correspond to the position of the oil nozzles. IMPORTANT: Class A pistons are supplied as spares and they can also be fitted in a class B cylinder liner. 3. The order for fitting the connecting rod-piston assembly in the cylinder liner is:

connecting rod-piston assembly; punch mark area on the top of the piston with symbols for assembly position and selection class and (3) , connecting rod punch mark area. mid0332a 2 mid0333a 3 9671 1 27/05/2004 B.10.A / 91