POWER PRODUCTION - ENGINE 4. Connect the connecting rods to the relevant pins of the crankshaft. Fit on the caps of the connecting rod (1) , together with the half bearings. Screw down the fixing screws (2) , and tighten them in two stages to the torques given in the table at: Cylinder head - Torque (B.10.A.72 - D.20.A.10) . IMPORTANT: The connecting rod cap fixing screws of the engine must be lubricated with engine oil before assembly. 5. Angle closing is performed with tool 380000304 , (3) . Remove the caps and determine the existing clearance, comparing the width of the calibrated wire with the graduated scale on the bag containing the wire. IMPORTANT:
Lubricate all relevant parts before final assembly with engine oil. Before reusing the connecting rod cap fixing screws, measure the thread diameter. If a connecting rod cap fixing screw diameter is lower than 13.4 mm ( .528 in ), it must be replaced. mid0334a 4 9671 1 27/05/2004 B.10.A / 92