POWER PRODUCTION - ENGINE Flywheel - Install (B.10.A.50 - F.10.A.15) AFX8010 1. Details of the punch marks on an engine flywheel which indicate piston position are: "A" - Hole on flywheel with 1 notch, corresponding to the TDC of pistons 3-4; "B" - hole on flywheel with 1 notch, corresponding to the TDC of pistons 1-6; "C" - hole on flywheel with 1 notch, corresponding to the TDC of pistons 2-5 and "D" - hole on flywheel with 2 notches, position corresponding to 54 ° . IMPORTANT: If the teeth of the rim mounted on the engine flywheel for starting the engine are badly damaged, replace the rim. Assembly must be done after heating the rim to a temperature of 200 °C ( 392 °F ). mid0344a 1 2.
Fit the engine flywheel without locking the fixing screws (2) and insert the pin 380000150 (1) . IMPORTANT: The engine flywheel fixing screws must be lubricated with engine oil before assembly. 3. Lock flywheel rotation with tool 380000144 , (1) ; and tighten the screws, (2) , as noted in Flywheel - Torque (B.10.A.50 - D.20.A.10) . 4. Second phase: closed angle with tool 380000304 , (1) . Refer to Flywheel - Torque (B.10.A.50 - D.20.A.10) . 9671 1 27/05/2004 B.10.A / 93