Case IH AFX8010 — ENGINE

POWER PRODUCTION - ENGINE Cylinder block - Measure (B.10.A.70 - F.40.A.16) AFX8010 IMPORTANT: Handle all parts carefully. Do not put your hands or fingers between parts. Wear suitable safety clothing - safety goggles, gloves and shoes. 1. Check the inside diameter of the cylinder liners to verify the extent of ovalization, taper and wear with the gauge (2) , equipped with a dial gauge (1) , 380000153 of diameter 125 mm ( 4.921 in ). If the ring gauge is not available, use a micrometer. 2. Outline for Measuring the Diameter of the Cylinder Liners (dimensions in mm) are: (1) first measurement; (2) second measurement and (3) , third measurement.

The measurements have to be made on each single cylinder liner at three different heights and on two planes (A-B) at right angles to each other, as shown in the figure to the right. Dimensions for the two planes are: A, 125 - 125.013 mm ( 4.9213 - 4.9218 in ); B, 125.011 - 125.024 mm ( 4.9217 - 4.9222 in ). mid0383a 1 mid0384a 2 3. On finding greater wear than 0.150 mm ( 0.0059 in ) or maximum ovalization of 0.100 mm ( 0.0039 in ) over the values given in the figure, it is necessary to replace the cylinder liner as grinding, lapping and dressing are not permitted. The "X" in the illustration indicates selection class marking area. IMPORTANT:

The cylinder liners are supplied as spares with selection Class A. Class B is mounted solely in production. mid0385a 3 9671 1 27/05/2004 B.10.A / 94