Case IH AFX8010 — ENGINE

POWER PRODUCTION - ENGINE Cylinder head - Assemble (B.10.A.72 - F.10.A.20) AFX8010 1. Assemble the camshaft bushing installer 380000146 . To fit the bushings 1 - 2 - 3 - 4 - 5 - 6; proceed as follows: 1. Position the bushing to mount on the drift (A) making its grub screw coincide with the seat on the bushing. 2. Position the guide bushing (E) and secure the guide bushing (G) on the seat of the 7th bushing with the plate (H) . 3. When driving in the bushing, make the reference mark (F) coincide with the mark (M) . In this way, after driving it home, the hole in the bushing for lubrication coincides with the oil duct in it seat.

The bushing is completely driven home when the first yellow reference mark (D) is flush with the guide bushing (G) . MID0443A 1 IMPORTANT: To remove the bushings from the cylinder head it is necessary to make the grub screw of the tool 380000146 coincide with the bushing. 2. To mount the bushing 6: Unscrew the grip (1) and the extension (N) . Position the extension (N) and the guide bushing (E) as shown in the figure above. Repeat steps 1, 2, and 3 performed for driving in the bushings 1, 2, 3, 4 and 5. MID0444A 2 3. To mount the 7th bushing: Remove the grip and the guide bushing (G) secured to the cylinder head (see figure above).

Fit the guide (G) back on without securing it with the plates. Position the bushing on the drift (A) and bring it up to its seat. Make the hole in the bushing coincide with the lubrication hole on the head, then fit the bushing. IMPORTANT: The bushing is driven in correctly when the reference C is flush with the bushing seat. MID0445A 3 9671 1 27/05/2004 B.10.A / 100