POWER PRODUCTION - ENGINE 4. Lubricate the stem of the valves and insert them in their valve guides. Mount the bottom plates (3) . Fit the oil seal (1) , on the valve guide (2) , then mount the valves as follows. MID0448A 4 5. The surfaces of the bushings must have no sign of seizing or scoring; and must be replaced if they do. Using a bore gauge, measure the inside diameter of the bushings. If it is above the tolerance value, replace the bushings. To disassemble and reassemble the bushings of the camshaft, use the drift A: 380000146 . B. Bushing positioning grub screw; C. Reference for fitting the 7th bushing; D. Reference for fitting bushings:
1 - 2 - 3 - 4 - 5 - 6, reference mark for the F2B engine, red mark for the F3A engine; E. Guide bushing; G. Guide bushing to secure to the 7th bushing mount; H. Plate for securing bushing G to cylinder head; I. Grip, and L. Extension coupling. MID0442A 5 6. Mount the springs (6) and top plate (5) . On the cylinder head, fit as suitable valve spring compressor (2) . Secure it with the bracket (4) . Screw down the lever (1) , until it is possible to mount the cotter pins (3) , then remove the tool (2) . Check the rocker arm shaft and all mating surfaces to ensure that they have no scoring or signs of seizing. If they do, replace any damaged parts.
Check the clearance between the bushings of the rocker arms and the shaft. If you find the bushings worn, replace the entire rocker arm. MID0449A.jpg 6 9671 1 27/05/2004 B.10.A / 101