POWER PRODUCTION - ENGINE Cylinder head - Install (B.10.A.72 - F.10.A.15) AFX8010 1. Check that pistons 1-6 are exactly at TDC. Place the gasket (2) , on the crankcase. Fit the cylinder head (1) and tighten the fixing screws according to the tightening sequence given in the Cylinder head - Torque (B.10.A.72 - D.20.A.10) section. IMPORTANT: The cylinder head fixing screws of the engine must be lubricated with engine oil before assembly. mid0335a 1 2. Cylinder head tightening sequence for the fixing screws are shown in section Cylinder head - Torque (B.10.A.72 - D.20.A.10) . 3. Pre-tightening information using a torque wrench can be found at Cylinder head - Torque (B.10.A.72 - D.20.A.10) .
mid0337a 2 4. Angle closing with tool 380000304 (1) and refer to Valve drive - Torque (B.10.A.40 - D.20.A.10) . mid0338a 3 9671 1 27/05/2004 B.10.A / 102