POWER PRODUCTION - ENGINE Cylinder head - Measure (B.10.A.72 - F.40.A.16) AFX8010 1. Before removing the cylinder head, check the hydraulic seal with the appropriate equipment. Replace the cylinder head if there is any leakage. IMPORTANT: Handle all parts carefully. Do not put your hands or fingers between parts. Wear suitable safety clothing - safety goggles, gloves and shoes. 2. Check the mating surface (1) , of the head on the cylinder assembly with a rule (2) and a feeler gauge (3) . If you find any deformation greater than 0.2 mm ( 0.008 in ), replace the cylinder head. IMPORTANT: After this process you need to check the valve cavity and injector protrusion. mid0447a 1 3.
Decarbonize the valves using the specific metal brush. Check that the valves show no signs of seizure or cracking and in addition, check with a micrometer that the diameter of the valve stem falls within the required values; if it does not, replace the valves. Using a micrometer, check that the diameter of the valve stems are 8.960 - 8.975 mm ( 0.3528 - 0.3533 in ). 4. The main data of the valves and valve guides are shown in the figure to the right (all dimensions are in mm). An * indicates the measurement to make after driving in the valve guides, (1) , showing intake valve and (2) , indicating the exhaust valve.
If necessary, grind the seats on the valves with a valve grinding machine, scalping as little material as possible. Using a dial gauge with a magnetic base, check the clearance between the valve stem and the relevant guide. Refer to Valve drive - Dimension (B.10.A.40 - D.40.A.30) . If the clearance is too great, replace the valve and if necessary, the valve guide. mid0448a 2 mid0449a 3 9671 1 27/05/2004 B.10.A / 103