POWER PRODUCTION - ENGINE ENGINE - Troubleshooting (B.10.A - G.40.A.10) AFX8010 ATTENTION: Before troubleshooting the engine, make sure the following operating conditions are met: 1. Electrical troubleshooting has to have been performed with specific testing instruments. 2. The air system must be operating properly. 3. The engine must have the proper oil pressure. If the engine runs but has an occasional or non-constant problem, check the earth connections on connector B of the control unit PIN 1 and PIN 2.
9671 1 27/05/2004 B.10.A / 106 Problem Possible Cause Correction Engine Fails to Start Low charge in batteries Recharge and/or replace batteries; check alternator output Poor connections at battery terminals Check, clean, tighten and/or replace the terminals Starter motor inoperative Check connections and/or replace starter Air intake heater inoperative Check heater feed and ground wiring connections; check heater relay for proper operation; perform diagnostic test Main relay not functioning or fuse inoperative Check and replace relay or fuse Fuel supply pump fails to prime (incoming air) Check seal on intake branch; check pressure on filter inlet Fuel circuit not correctly filled (air in the circuit) Check seal; bleed fuel lines.
Refer to steps 15 through 17 of Fuel injector - Install (B.20.A.29 - F.10.A.15) Fuel filter and/or pre-filter clogged Replace filters, as required Engine Overheats Coolant level under minimum Check for hose/radiator leaks; top off with fluids to level indicator Fan and water pump drive belt not operating properly Check belt tension and/or replace belt; check for water leaks from water pump drainage hole Water pump not operating properly or is leaking Replace water pump.
Thermostat jammed shut or partially open Replace thermostat Radiator clogged on outside Wash and/or blow out debris; replace radiator Air filter clogged or sleeves closed Check filter clogging indicator; clean or replace filter Cylinder head gasket shows compression blow-by from cylinder head gasket Check water circuit pressure; replace head gasket (see steps 1 and 2 of Cylinder head - Install (B.10.A.72 - F.10.A.15) Low Power, Fuel Consumption Too High, Noisy Engine Mesh filter on fuel tank clogged Clean screen Fuel pre-filter clogged Replace pre-filter Fuel filter clogged Replace fuel filter Air in circuit Check intake seals (quick couplings, when hot) Valve 0.8 bar on fuel return from cylinder head due to being jammed open (low pressure); jammed shut (high temperature) Replace valve Bad fuel leakage Check and/or repair leak Supply pump broken (seized, broken coupling, pressure adjustment valve, etc.) Check pressure on filter inlet and/or replace supply pump Irregular fuel injector operation Replace injector(s).
Refer to Fuel injector - Install (B.20.A.29 - F.10.A.15) Fuel leakage from injector O rings Check for fuel in the engine Air supply filtration to engine (constricted and/or clogged filter) Check cartridge clogging indicator; clean and/or replace filter