POWER PRODUCTION - ENGINE 9671 1 27/05/2004 B.10.A / 107 Problem Possible Cause Correction Gas exhaust leakage at exhaust manifold Check and/or repair leak Turbo blade or bearing noise Check and/or replace turbocharger Turbocharger waste-gate valve not operating properly Adjust valve and/or replace waste-gate valve and adjust Excessive injector control cam wear Check and/or replace injector control cams, as required Excessive or no valve clearance Check and/or adjust valve clearance.
Refer to Valve drive - Dimension (B.10.A.40 - D.40.A.30) Grey-White Smoke From Engine Exhaust Water in cylinders due to head gasket leakage Check water circuit pressurization liquid level and/or replace head gasket (see steps 1 and 2 of Cylinder head - Install (B.10.A.72 - F.10.A.15).
Water in cylinders due to injector sheath leakage Check and/or replace injector sheaths Water in cylinders due to incoming water from intake system Repair leak Water in cylinders due to water in diesel fuel Check for water in fuel tank and clean or drain fuel tank Blue Smoke From Engine Exhaust Oil in cylinders with excessive oil consumption Repair engine as required Oil in cylinders with oil blow-by from turbine Repair engine as required Oil in cylinders with blow-by from valve guide Repair engine as required Engine Stalls or Stops Combine is overloaded Reduce harvesting speed Fuel tank is empty; no diesel fuel Refuel and bleed fuel line circuit.
(Refer to steps 15 through 17 of Fuel injector - Install (B.20.A.29 - F.10.A.15) for bleeding procedure). Mesh filter, pre-filter or fuel filter clogged Clean and/or replace, as required. (Refer to steps 15 through 17 of Fuel injector - Install (B.20.A.29 - F.10.A.15) for bleeding procedure). Trouble with fuel circuit; refer to ENGINE - Low performance (B.10.A - G.10.E.50). Refer to ENGINE - Low performance (B.10.A - G.10.E.50). Idling speed too low Adjust as required Main relay not operating Replace relay