POWER PRODUCTION - FUEL AND INJECTION SYSTEM Fuel injector - Remove (B.20.A.29 - F.10.A.10) AFX8010 IMPORTANT: Handle all parts carefully. Do not put your hands or fingers between parts. Wear suitable safety clothing - safety goggles, gloves and shoes. 1. From underneath the vehicle, take the inspection cover off the timing system gearbox. Fit the flywheel rotation tool on the gearbox (2) , 296179 (7) and spacer 296180 (6) . IMPORTANT: The arrow shows in which direction the engine turns. Using the above-mentioned tool, turn the engine flywheel (1) , in the direction of rotation of the engine so as to bring the piston of cylinder no. 1 approximately to the TDC in the phase of combustion.
This condition is accomplished when the hole with one reference mark (4) , after the hole with two reference marks (5) , on the engine flywheel (1) can be seen through the inspection window (3) . MID0484B 1 2. The exact position of the piston of cylinder no. 1 at the TDC is obtained when, in the above-described conditions, the tool 296192 (1) , enters the hole (3) , in the engine flywheel (4) through the seat (2) , of the engine speed sensor. If this is not the case, turn the engine flywheel (4) appropriately. Remove the tool 296192 (1) . MID0485B 2 9672 1 27/05/2004 B.20.A / 21