POWER PRODUCTION - FUEL AND INJECTION SYSTEM Fuel injector - Install (B.20.A.29 - F.10.A.15) AFX8010 1. The injectors must be replaced with great care. IMPORTANT: If the job is done with the engine in the vehicle, and before disassembling the pump injectors, drain off the fuel contained in the pipes in the cylinder head by unscrewing the delivery and return fittings on the cylinder head. 2. For each injector replaced, hook up to the electronic diagnostic station or instrument, and when directed by the program, enter the code number stamped on the injector to reprogram the control unit.
Refer to FUEL AND INJECTION SYSTEM - General specification (B.20.A - D.40.A.10) for the code number for your specific application. mid0496a 1 IMPORTANT: If the electronic diagnosis instrument is not available, it is nearly impossible to replace an injector without the control unit identification. IMPORTANT: When checking the rocker arm clearance, you must check the pump injector preload. Refer to Fuel injector - Preload (B.20.A.29 - F.45.A.30) . 3. Thoroughly clean the pump injector seats and the pump injectors. Mount the ring seals (1) , (2) and (3) , on the injectors. mid0352a 2 9672 1 27/05/2004 B.20.A / 23