Case IH AFX8010 — FUEL AND INJECTION SYSTEM

POWER PRODUCTION - FUEL AND INJECTION SYSTEM 12. Using tool 380000128 (3) , constrain the sliding blocks (4) , to the rocker arms (3) . Apply tool 380000148 (1) , to the rocker arm shaft (5) , and position it on the cylinder head. IMPORTANT: Before reassembling the rocker arm shaft assembly, make sure all the adjustment screws are fully unscrewed. MID0492B 11 13. Tighten the screws (2) , fixing the rocker arm shaft in two stages: Stage 1: tightening with a torque wrench (1) , to a torque of: 100 Nm (10 kgm [ 73 lb ft ]). Stage 2: closing, with tool 380000304 (3) , with an angle of 60 ° . 14. Constrain the levers (1) , to the spacer (3) , with the springs (2) .

To adjust the rocker arm clearance, see Valve drive - General specification (B.10.A.40 - D.40.A.10) . Mount the rocker arm cover using a new gasket. Tighten the fixing screws to the required torque noted in Valve drive - Torque (B.10.A.40 - D.20.A.10) and in the tightening sequence shown in Valve drive - Dimension (B.10.A.40 - D.40.A.30) . MID0493B 12 MID0494B 13 9672 1 27/05/2004 B.20.A / 28