Case IH AFX8010 — FUEL AND INJECTION SYSTEM

POWER PRODUCTION - FUEL AND INJECTION SYSTEM 15. Before starting the engine, it is necessary to bleed the fuel supply system. Starting with the pre-filter, fit a tube to the bleed screw (1) and bleed the fuel into a container by turning the key switch to the ON position (3) , until fuel flows out through the screw (1) , without any air bubbles in it. Tighten the screw and remove the tube. IMPORTANT: Handle all parts carefully. Do not put your hands or fingers between parts. Wear suitable safety clothing - safety goggles, gloves and shoes. MID0495B 14 16. Attach a tube to the bleed screw (2) , on the support filter.

Open the screw and then operate the pump on the pre-filter mount until fuel flows without any air bubbles in it. Tighten the screw and remove the tube. MID0496B 15 17. Attach a tube to the bleed screw (4) , located on the front of the cylinder head. Open the screw and then operate the pump on the pre-filter mount until fuel flows without any air bubbles in it. Tighten the screw and remove the tube. IMPORTANT: To reduce premature failure, never let fuel contaminate the drive belts of the alternator, water pump, etc. If a belt becomes contaminated, replace the belt. MID0524B 16 9672 1 27/05/2004 B.20.A / 29