POWER PRODUCTION - ENGINE UNIVERSAL DISPLAY PLUS FAULT CODE 0420.2 BATTERY VOLTAGE, DATA INCORRECT 0420.3 BATTERY VOLTAGE, SHORTED TO HIGH SOURCE 0420.4 BATTERY VOLTAGE, SHORTED TO LOW SOURCE Cause: Battery voltage to ECU below minimum value ( 18V) Effect on Engine: Engine enabled -- no restriction on fuel or speed Possible failure modes: 1. Excessive resistance on wiring to ECU. 2. Short to high voltage source (24V starting circuit) 3. Alternator failure Solution: When the key switch is turned to the “Run” position, power is sent to the ECU.
When the ECU receives this power, it immediately provides a ground path for the K14 ECU Power relay, so that the relay energizes, and provides the main power supply for the ECU. When the key switch is turned to the “Off” position, the ECU continues to provide a ground path for the K14 relay in order to complete a controlled shutdown of the engine. After approximately 5 seconds, the ECU opens the ground path for the K14 relay, disconnecting the main power supply. The error message “E0420--03 Battery Voltage – Shorted to High Source” will occur if the main power supply through the K14 relay is greater than 18 volts. Start the troubleshooting at step 7.
The error message “E0420--04 Battery Voltage Shorted to Low Source” will occur if the main power supply through the K14 relay is 5 to 7 volts. The ECU will not power up if the voltage is below 5 volts. Start the troubleshooting at step 1. 1. Turn the key switch to the “Run” position. Check the voltage at fuse F01; it should be approximately 12 volts. A. If the voltage is less than 12 volts, there is excessive resistance in the fuse panel wiring to fuse F01. Check the battery cable connection to the fuse panel, and the wiring from the battery cable to fuse F01 on the back of the panel. B. If the voltage is approx. 12 volts, continue with step 2. 2.
Remove the K14 ECU Power relay from the fuse panel. Check the voltage at the K14 mounting socket pin 3; it should be approx. 12 volts. A. If the voltage is less than 12 volts, there is excessive resistance in the fuse panel wiring between fuse F01 and K14 relay pin 3. Inspect wiring and connections. B. If the voltage is approx. 12 volts, continue with step 3. 3. Install a jumper wire between pin 3 and pin 5 of the K14 relay mounting socket. Remove connector X004 , and check the voltage at connector X004 pin 25 ; it should be approx. 12 volts. A.
If the voltage is less than 12 volts, there is excessive resistance in the cab main (CM) harness between connector X004 pin 25 and K14 relay mounting socket pin 5 wire 809 white. Inspect the wiring and repair. B. If the voltage is approx. 12 volts, continue with step 4. 4. Remove connector X010 , and check the voltage at connector X010 pin 28 ; it should be approx. 12 volts. A. If the voltage is less than 12 volts, there is excessive resistance in the main frame (MF) harness between connector X004 pin 25 and connector X010 pin 28 wire 809 white. Inspect the harness and connectors and repair. B. If the voltage is approx. 12 volts, continue with step 5. B.20.A / 129