POWER PRODUCTION - AIR INTAKE SYSTEM Sensing system Air cleaner restriction - Short circuit to B+ (B.30.A.95.95 - G.30.B.54) AFX8010 E0163-03 - Air Filter Sensor Cause: The engine air filter switch (S-61) circuit is shorted to 12 volts. Possible failure modes: 1. Switch supply or signal wiring shorted to 12 volts . 2. Switch ground path open. 3. Engine controller internal failure (internal regulator failure). Solution: 1. Enter the Universal Display Plus "DIAG" screen. Select the "ENGINE" sort menu, and select "AIR FILTER SEN" to check the voltage range. The proper voltage range for the engine air filter switch (key On, engine OFF or Running) is 0.3 - 5.2 volts . A.
If the voltage reading is high out of range (> 5.2 volts ), continue with Step 2 . B. If the voltage is in the proper range, the shorted wire may not be energized at this time. Continue with Step 7 . NOTE: Visually inspect the wiring harness and connectors. Verify that the connector was fully installed. Inspect the terminals and wires at the connector for pushed back or corroded terminals or damaged wires. Flex the harnesses involved to reveal intermittent breaks or shorts in the wiring concerned. 2. Disconnect the resistor plug at connector X330 . Use a multimeter to check for voltage on connector X330 pin B. There should be 5 volts present. A.
If high (> 5.5 volts ) voltage is found, the regulated voltage supply is incorrect. The error " E0165-03 - CCM2 J2 5V Reference " should be listed in the Universal Display Plus "ERROR" screen. Correct that error, and then check to determine if this error has been resolved. B. If correct voltage is found, continue with Step 3 . 3. Disconnect the air filter pressure switch connector X202 . Use a multimeter to check for continuity between connector X202 pin 1 and chassis ground. A. If continuity is found, continue with Step 5 . B. If no continuity is found, continue with Step 4 . 4. Disconnect the engine (EN) harness from the main frame (MF) harness at connector X010 .
Use a multimeter to check for continuity between the main frame (MF) harness end of connector X010 pin 14 and chassis ground. A. If there is continuity, there is an open circuit in the engine (EN) harness between connector X010 pin 14 and connector X202 pin 1 wire 851 blue or 468 blue. Locate the open and repair. B. If there is no continuity, there is an open circuit in the main frame (MF) harness between connector X010 pin 14 and connector X016 pin J2-14 wire 468 blue, 425 blue or 465 blue. Locate the open and repair. 5. Disconnect the air filter pressure switch connector X202 . Use a multimeter to check for voltage between connector X202 pin 2 and chassis ground. A.
If high (> 5.5 volts ) voltage is found, continue with Step 6 . B. If no voltage is found, continue with Step 7 . 9673 1 27/05/2004 B.30.A / 19