100 CHAPTER SIX Have the engine model number and serial number avail- able when ordering parts. Record the engine model and serial numbers and store them for future reference in case the identification plate on the engine is defaced or lost. REPLACEMENT PARTS When installing new parts on the engine, make sure the part is designed for use on a marine engine. Automotive and marine engine parts may look similar; however, auto- motive parts may not be capable of operating in a harsh marine environment. Use only Yanmar parts or parts approved for use on ma- nne engmes. ENGINE Precautions Some service procedures can be performed with the en- gine in the boat; others require removal.
The boat design and service procedure to be performed determines whether the engine must be removed. WARNING The engine is heavy, awkward to handle and has sharp edges. It may shift or drop sud- denly during removal. Toprevent serious in- jury, always observe the following precautions. 1. Never place any part of your body where a moving or falling engine may trap, cut or crush you. 2. If you must push the engine during removal, use a board or similar tool to keep your hands out of danger. 3. Be sure the hoist is designed to lift engines and has enough load capacity for the engine. 4. Be sure the hoist is securely attached to safe lifting points on the engine. 5.
The engine should not be difficult to lift with a proper hoist. If it is, stop lifting, lower the engine back onto its mounts and make sure the engine has been completely separated from the vessel. the freshwater system, if so equipped, as described in Chapter Four. 3. Disconnect the intake water hose from the seawater cooling pump. 4. Close the fuel shutoffvalve and disconnect the fuel line and the fuel return line. 5. Disconnect the remote control cables. 6. Disconnect the electrical wiring harness connectors. 7. Disconnect the electrical wires from the electric starter motor and solenoid that will interfere with engine removal. 8. Detach the exhaust system. 9.
Detach the driveshaft from the transmission output flange. 10. Remove the engine retaining bolts. 11. Remove the engine and transmission. 12.Remove the transmission from the engine as described in Chapter Ten or Eleven. Removal/Installation While specific procedures cannot address all engine in- stallations, refer to the following general instructions when removing the engine: 1.Detach the negative battery cable from the negative bat- tery terminal. 2. Close the seacock. Drain the cooling system, including