Yanmar — Yanmar Diesel Inboard Shop Manual for One, Two, and Three Cylinder Engines

MULTI CYLINDER ENGINES 101 VALVE COVER (2GM, 2GM20, 3GM AND 3GM30 MODELS) 1. Valve cover 2. Gasket 3. O-ring 4. Decompression shaft 5. Decompression lever 6. Washer 7. Nut 8. Spring 9. Detent ball 10. 011 fill cap 11. O-ring 12. Nut 13. O-ring 14. Pin 15. Breather 16. Gasket 17. Hose 18. Baffle 2 13. Engine installation is the reverse of removal, plus the following: a. Tighten the engine mounting bolts securely. b. Securely tighten the output flange-to-driveshaft bolts. c. Bleed the fuel system at the fuel filter as described under Fuel Filter in Chapter Three. d. Refill the freshwater cooling system, if so equipped, as described in Chapter Eight. 2. Disconnect the breather hose. 3.

Unscrew the retaining nuts. 4. Remove the valve cover. 5. Remove the gasket. 6. Clean the gasket surfaces on the valve cover and cylin- der head. 7. Reverse the removal steps to install the valve cover. BREATHER ASSEMBLY VALVE COVER The crankcase breather is located in the valve cover. Refer to Chapter Three for a description of breather opera- tion. To service the breather, proceed as follows: 1. Remove the valve cover. 2. Remove the breather cover. Refer to Figure 3 and Figure 4 for an exploded view of the valve cover assembly. To remove the valve cover, proceed as follows: 1. Be sure the decompression lever is in the OFF position.