102 CHAPTER SIX VALVE COVER 3HM AND 3HM35 MODELS 1. Valve cover 2. Gasket 3. a-ring 4. Decompression shaft 5. Decompression lever 6. Washer 7. Nut 8. Spring 9. Detent ball 10. Oil fill cap 11. a-ring 12. Nut 13. a-ring 14. Pin 15. Breather 16. Gasket 17. Hose 18. Upper baffle 19. Filter 20. Lower baffle 3. Clean the breather components and valve cover using solvent. Be sure the drain hole in the valve cover is open. 4. 3HM and 3HM35 models-Replace the mesh breather element if it cannot be cleaned or if it is damaged. 5. Reassemble the breather by reversing the disassembly procedure. Note that the lower baffle (20, Figure 4) on 3HM and 3HM35 engines is smaller than the upper plate (18).
Ifthe mechanism must be repaired, proceed as follows: 1. Remove the valve cover as previously described. 2. Using a suitable punch, drive out the retaining pin. NOTE The detent ball and spring will be loose when you remove the shaft assembly in Step 3. DECOMPRESSION MECHANISM 3. Remove the shaft assembly from the valve cover. The decompression mechanism on the valve cover forces the exhaust valves open to reduce compression pressure in the cylinders. Reducing compression pressure enables the starter to rotate the crankshaft faster during starting. Refer to Figure 3 and Figure 4. 4. Inspect the mechanism and replace the damaged parts. 5.
Reverse the removal procedure to reassemble the de- compression mechanism. Note the following: a. Assemble the shaft and lever so the lever points up while the flat on the valve end of the shaft is down.