MULTI CYLINDER ENGINES 103 o EXHAUST MANIFOLD 2GM AND 2GM20 MODELS 3GM, 3GM30, 3HM AND 3HM35 MODELS EXHAUST MANIFOLD 2. Loosen the hose clamps and remove the water hose from the exhaust elbow and thermostat housing. 3. Remove the exhaust elbow from the cylinder head. 4. Clean any gasket residue from the exhaust elbow and cylinder head. 5. Check the exhaust elbow for warpage, carbon buildup and corrosion. 6. Reinstall the exhaust elbow by reversing the removal procedure. Tighten the retaining nuts to the torque speci- fied in Table 2. On 2GM models, the exhaust manifold is an elbow that is attached to the cylinder head (Figure 5).
A hose from the thermostat cover directs cooling water into the exhaust elbow. On 3GM models, the exhaust manifold contains water passages that allow water to cool the manifold. A hose from the thermostat cover directs cooling water into the exhaust manifold (Figure 5). A hose from the exhaust manifold directs water from the exhaust manifold into the exhaust elbow. The exhaust manifold on 2GMF, 2GM20F, 3GMF, 3GM30F, 3HMF and 3HM35F models is combined with the coolant reservoir for the freshwater (closed) cooling system (Figure 6). Refer to Chapter Eight for a descrip- tion of the freshwater (closed) cooling system. 3GM, 3GM30, 3HM and 3HM35 models with seawater cooling Refer to Figure 5. 1.
Detach the exhaust hose from the exhaust elbow. 2. Loosen the hose clamps and remove the water hose from the exhaust manifold and thermostat housing. 3. Open the drain valve on the underside of the exhaust manifold. 4. Remove the exhaust manifold from the cylinder head. 5. Ifnecessary, remove the water hose and exhaust elbow from the exhaust manifold. Removal and Installation 2GMmodeis Refer to Figure 5. 1. Detach the exhaust hose from the exhaust elbow.