Yanmar — Yanmar Diesel Inboard Shop Manual for One, Two, and Three Cylinder Engines

108 CHAPTER SIX Feeler gauge cleaning. look for cracks or other visible signs of damage. Clean the passages with a stiff spiral brush. then blow them out with comp ressed air. N OT E Ifdepasits aref ound in the intake or exhaust por ts, remove the valves and de an the port s. 6. Clean away all carbon on the piston top. 7. Chec k the cylinder head studs for damage and replace them if necessary, Ir a stud is loose, tighten it using the fol- lowing procedure: uo~C ~'") oD o 0 o a. Install I\\'O nuts on the stud as shov...n in Figure 11. typical. b. Rotate the nuts so they contact each other. then hold onc nut and lighten the other nut against the first nut. c.

Tighten the stud in the cylinder block by turning the top nut until reaching a torque of 60 Nom (44 ft.-lb.). d. Hold the bottom nul, loosen the top nut, and remove both nuts. 8. Check the threaded rocker ann support stud for dam- aged threads. Replace if necessary. 9. Check for warpage of the cylinder head-to-block gas- ket surface with a straightedge and feeler gauge (Ftgure 12). Measure diagonally, as well as end to end. If the gap exceeds 0.07 mm (0.003 in.). have the head resurfaced by a machine shop. 0 0 o o 4. Place the new head gasket over the cylinder head studs on the block. Be sure the TOP mark (Figure 13) on the gasket is up. 5. Carefully lower the head onto the cylinder block.

6. Apply engine oil to the threads on the cylinder head studs. 7. Install and tighten the cylinder head retaining nuts fin- ger-tight. 8. Tighten the nuts and bolts following the sequence shown in Ftgurc 14 to the torque specified in Table 4. Tighten the nuts and bolts in three equal steps until reach- ing the final torque setting. 9. If removed, install the sacrificial anode into the cylin- der head. Installation I. Make sure the cylinder head and block gasket surfaces are clean. 2. Recheck all visible oil and water passages for cleanli- ness. 3. Apply Three Bond 50 gasket scaler to both sides of a new cylinder head gasket. 10. Attach the oil line fitting 10 the cylinder head. II.

Install the push rods in their original position.