MULTICYLINDER ENGINES 109 CYLINDER HEAD TIGHTENI~G SEQUENCE Flywheel 2·CYLINDER Flywheel Gear 20. Adjust the valve clearance as described in Chapter Three. 21. Reinstall the valve cover. 3·CYLINDER ROCKER SHAFT ASSEMBLY Each valve is actuated by a rocker arm that rides on a shaft (Figure 8). Each rocker arm is equipped with a bushing in the rocker arm bore. A snap ring at each end of the rocker arm shaft retains the rocker arms on the rocker shafts. 1. Remove the valve cover as previously described. 2. Remove the rocker arm stand retaining nuts (Figure 10), then remove the rocker shaft assembly. 12. Install the rocker assembly and the rocker arm stand retaining nuts (Figure 10).
Tighten the nuts to 37 Nom (27 ft.-lb.). 13. Install the fuel injector and precombustion chamber as described in Chapter Seven. 14. Install the exhaust manifold. 15. Install the air cleaner base and the air cleaner. 16. Connect the wire lead to the water temperature sender (Figure 9). 17 A. Engines with standard cooling-Connect the lower water hose (Figure 9). 17B. Engines with freshwater (closed) cooling sys- tem-Install the freshwater pump as described in Chapter Eight. 18. Install the alternator. 19. If the engine is installed in the boat, proceed as fol- lows: a. Attach the exhaust hose to the exhaust elbow. b.
On engines equipped with a closed cooling system, fill the cooling system as described in Chapter Four. c. Connect the negative battery cable to the negative battery terminal. NOTE The rocker arms on 2GM and 2GM20 en- gines are identical, but rocker arms on 3GM, 3 GM30, 3HM and 3HM35 engines are designed for use with the intake or ex- haust valves. 3. Remove the snap rings at both ends ofthe rocker shaft and remove the rocker shaft components. 4. If necessary, unscrew the locating screw in the end support stand (Figure 15) and separate the rocker shaft from the stand. 5. Inspect each rocker arm. The pad on the rocker arm that contacts the valve stem must be smooth.
Replace the rocker arm if the pad is damaged or excessively worn. Check the adjusting screw push rod seat for galling. Re- place the adjusting screw if it is damaged or excessively worn.