Yanmar — Yanmar Diesel Inboard Shop Manual for One, Two, and Three Cylinder Engines

110 CHAPTER SIX ROCKER ARMS (3GM, 3Gr.,30, 3HM AND 3HM35 MODELS E Flat INTAKE EXHAUST VALVE COMPONENTS 6. Inspect and measure the inside diameter of the rocker arm bushing and the outside diameter of the rocker arm shaft. Replace the rocker arm or rocker arm shaft if the measurements exceed the specifications listed in Tables 1-3. NOTE The rocker arm and bushing are available only as a unit. 7. Reassemble and reinstall the rocker arm assembly by reversing the removal procedure. On 30M, 30M30, 3HM and 3HM35 engines, identify the intake and exhaust valves as shown in Figure 16, then position them on the shaft in the order shown in Figure 17. 8.

Adjust the valve clearance as described in Chapter Three. VALVES AND VALVE SEATS Servicing the valves, guides and valve seats must be done by a dealer or machine shop, as special knowledge and expensive machine tools are required. A general practice among those who do their own ser- vice is to remove the cylinder head, perform all disassem- bly except valve removal and take the head to a dealer or machine shop for inspection and service. Since the cost is low relative to the required effort and equipment, this is usually the best approach, even for experienced mechan- ics. The following procedures are provided to acquaint the home mechanic with the procedure. 1. Wear cap 2. Keys 3.

Valve spring retainer 4. Valve spring 5. Valve seal 6. Exhaust valve guide 7. Intake valve guide 8. Exhaust valve 9. Intake valve