MULTICYLINDER ENGINES 111 Valve Removal Refer to Figure 18 for this procedure. 1. Remove the cylinderhead as described in this chapter. 2. Remove the rocker shaft assembly as described in this chapter. 3. Remove the wear cap (1, Figure 18) on the valve stem. 4. Compress the valve spring with a compressor like the one shown in Figure 19. 5. Remove the valve keys (2, Figure 18) and release the spring tension. 6. Remove the valve spring retainer and valve spring. CAUTION Remove any burrs from the valve stem lock grooves (Figure 20) before removing the valve to prevent damage to the valve guide. 7. Remove the valve. 8. Remove and discard the valve stem seal (5, Figure 18). 9.
Repeat Steps 3-8 for the remaining valves. 't----~-~Deburr Inspection 1. Clean the valves with a fine wire brush or buffing wheel. Discard any cracked, warped or burned valves. 2. Measure the valve stems at the top, center and bottom for wear. A machine shop can do this when the valves are ground. --.ii----- Valve stem NOTE Check the thickness of the valve edge or margin after the valves have been ground. See Figure 21. Any valve with a margin less than 0.75 mm (0.030 in.) should be dis- carded. 3. Remove all carbon and varnish from the valve guides with a stiff spiral wire brush. NOTE The next step assumes that all valve stems have been measured and are within specifi- cations.
Replace valves with worn stems be- fore performing this step. 4. Insert each valve into the guide from which it was re- moved. Holding the valve just slightly off its seat, rock it back and forth in a direction parallel with the rocker arms. This is the direction in which the greatest wear normally occurs. If the valve stem rocks more than slightly, the valve guide is probably worn. 5. If there is any doubt about valve guide condition after performing Step 4, measure the valve guide. Compare the t Valve head thickness