Yanmar — Yanmar Diesel Inboard Shop Manual for One, Two, and Three Cylinder Engines

112 CHAPTER SIX Exhaust valve guide Intake valve guide results with specifications in Tables 1-3. Worn guides must be replaced. 6. Test the valve springs under load on a spring tester (Figure 22). Replace any spring that does not meet the specification listed in Tables 1-3. 7. Inspect the valve seats. If worn or burned, they must be reconditioned.This is a job for a dealer or machine shop, although the procedure is described in this chapter. 8. Check each spring on a flat surface with a steel square. See Figure 23. Slowly revolve the spring 360 0 and note the space between the top of the coil and the square. If it exceeds 1.4 mm (0.055 in.) at any point, replace the spring. 9.

Check the valve guides for wear and looseness. Refer to Tables 1-3 for valve guide specifications. A loose valve guide must be replaced. Step cut Top Valve Guide Replacement The cylinder head is equipped with replaceable valve guides. The intake and exhaust valve guides are different in shape. Refer to Figure 24. The intake valve guide has a straight inside bore, while the exhaust valve guide has a stepped opening at the lower end of the guide. Take the cylinder head to a dealership or machine shop if valve guide replacement is required.