Yanmar — Yanmar Diesel Inboard Shop Manual for One, Two, and Three Cylinder Engines

MULT IC Y LIN DER ENG INES 123 OIL PICKUP 20M, 1GM10 , 3GM AND 3GM30 (TYPICAL) 6 , CRA:\"KS IIAFT Removal lind Ins tallati on Refer to Ffgure 61 for an exploded view of the crank- shaft assembly. I. Remove the flywheel as previously described. 2. Remove the bellhousing (A, Figure 62. typical). 3. Remove the piston and connecting rod as previously described. 4. Remove the oil pum p as previously described. 5. Remove the crankshaft: gea r. 6. Install a dial indicator as shown in Fi gure 63 and mea- sure cranksh aft: end play. Compare the measurement with the specification in Tabl es 1·3. If end play is excessive. inspect the main bearing as described in Main Bearings. 7.

Remove the main bearing housing (B, Figure 62, typi- cal). 8. Position the engine so the cranksha ft: is vertic al with the flywheel end up. 9. Attach a hoist to the flywheel end of the crankshaft. b. Heat the ring gear prior to installation. Drive the ring gear onto the flywheel while being careful not to damag e the gear teeth . NOTE Two-cylinder engines are equipped with one intermediate bearing carrier. Three-cylinder engines are equipped with two intemediate bearing carriers. 6. Reverse the removal procedure to install the flywheeL Tighten the flywheel retaining bolts to the tightening torque specified in T ab le 4.

Ref er to Chapters Ten and Eleven to install the drive disc and transmission. 10. Remove the retaining bolt(s) for the intermediate main bearing carrier(s). See Figure 64. DRIVE DISC NOTE Adj usting the lifting tension on the crank- shaft may ease or increase the force neces- sary to unscrew the retaining boll(s) for the intermediate main bearing camerts). Refer to Chapters Ten and Eleven for information con- cerning the drive disc (Figure 59).