122 CHAPTER SIX @ OIL PRESSURE REGULATOR 1. Plug 2. Shim 3. 011 pressure reliefspring 4. 011 pressure reliefball 5. Pipe 6. Nut 7. O-ring 8. 011 filter 8 Pressure reliefvalve FLYWHEEL An oil pressure relief valve is located in the oil filter mounting pipe (Figure 57). If oil pressure exceeds 300-400 kPa (43-57 psi), the reliefvalve opens and expels oil into the timing gearcase. Do not attempt to disassemble the oil pressure relief valve. The valve is sealed and it must be replaced as a unit assembly. Removal/lnstallation 1. Remove the engine from the boat. 2. Remove the transmission. 3. Remove the drive disc (Figure 59, typical). 4.
Gradually loosen and remove the flywheel bolts, working in a diagonal pattern. Install two drive disc screws into two outer holes in the flywheel (Figure 60, typical), then use the screws to pull and remove the fly- wheel. 5. Inspect the ring gear. If the ring gear is excessively worn or damaged, use the following procedure to remove the ring gear: a. Heat the ring gear evenly, then drive the ring gear off the flywheel. Oilpickup The oil pickup is located in the oil pan. The pickup in- cludes a strainer to prevent foreign matter from entering the lubrication system. To remove the oil pickup, remove the oil pan and un- screw the jam nut (Figure 58).