Yanmar — Yanmar Diesel Inboard Shop Manual for One, Two, and Three Cylinder Engines

MULTICYLINDER ENGINES 121 ___ ".-_ '--~ Straightedge 't--t"ri-- Outer rotor Feeler gauge Feeler gauge / 3. Thoroughly clean all parts in solvent and blow them dry with compressed air. 4. Check the drive spindle and pump rotors for signs of wear, scoring or damage. Replace damaged parts. NOTE The oil pump shaft and gear are pressed to- gether; do not attempt to disassemble them. The oil pump must be replaced as a unit as- sembly if any parts are damaged. Outer rotor ...... --Body -....,L---- Feeler gauge 5. Reinstall the inner rotor in the pump body. Reinstall the outer rotor in the pump body. 6. Measure the clearance between the inner rotor tip and outer rotor tip (Figure 54).

Compare the results with spec- ifications in Table 1. 7. Measure the clearance between the outer rotor and the pump body (Figure 55). Compare the results with specifi- cations in Table 1. 8. Place a straightedge across the pump body. Measure the side clearance between the rotors and straightedge with a flat feeler gauge (Figure 56). Compare the mea- surement with specifications in Tables 1-3. 7. Installation is the reverse of removal. Tighten the oil pump retaining screws to the tightening torque specified in Table 2. Be sure the governor flyweight assembly is po- sitioned on the locating pin (Figure 50).Tighten the crankshaft nut to the tightening torque specified in Table 4. 9.

Measure the diameter ofthe inner rotor shaft. Measure the shaft bore of the pump body. Calculate shaft clearance and compare it with specifications in Tables 1-3. 10. If any clearance measured in Steps 6-9 is not with specifications, replace the pump. Individual components are not available. The pump must be replaced as a unit. Disassembly, inspection and reassembly 2. Lift out the inner and outer pump rotors (Figure 53). 1. Remove the oil pump cover (Figure 52). 11. When reassembling the oil pump, be sure to lubricate the rotors, body and shaft with engine oil.