Yanmar — Yanmar Diesel Inboard Shop Manual for One, Two, and Three Cylinder Engines

120 CHAPTER SIX GOVERNOR ASSEMBLY Key Thru st Nul " bearing ) Cr ankshan Thrust PI" Thrust sleeve Gov ernor flyweights LUBR ICATION SYSTf:M Refer 10Chapter Two for lubrication system operation, diagrams and oil pressure test. Oil Pump The oil pump is mounted on the front (timing gea r) side of the cylinder block (Fig ur e 45). Removal and installation I. Remove the timing gearcase as previously described. 2. Remove the governor thrust washe r( Fig ur e 50), thrust bearing and thrust sleeve from the crankshaft. 3. Using a suitable tool (if available, Yanmar special tool 4. Remove the governor flyweight assembly. 5. Remove the oil pump (Fig ure 51) and gasket. 6.

Clean any gasket residue from the oil pump and en- gine. 124085-92700), unscrew the crankshaft nut.