MVLTlCYL INDER ENGINES 119 5. Remove the fuel injection pump as described in Chap- ter Seven. 6. Remove the seawater pump as described in Chapter Eight. 7. Remove the crankshaft pulley retaining nut. Using a suitable puller, remove the crankshaft pulley (Fi gure 46, typical). Remove the drive key from the crankshaft. 8. Remove the manual starter cover (Fi gure 47, typical). 9. Remove the setscrew in the end of the camshaft (A, Figure 48, typical), then remove the manual starter drive pin (B). ...-- 10. Remove the timing gearcasc (Figure 49). 6 11 . Remove the gaske t and any residue from the gearease L _ and crankcase surfaces. 12.
If crankshaft or starter seal replacement is necessary, proceed as follows: a. Pry the old seal from the gearcase with a large screwdriver. Work carefully to prevent damage to the gearcasc seal surface. b. Clean the seal recess in the cover with solvent and blow it dry with compressed air. c. Apply gasket sealer to the periphery of the seal. d. Position a new seal in the cover recess with its open end facing the inside of the gearcasc. Drive the seal into place with a suitably sized seal driver or socket. 13. If crankshaft bearing replacement is necessary, pro- ceed as follows: a. Refer to Chapter Seven and remove governor shaft from timing gearcase. b.
Pry the seal from the gearcase with a large screw- driver. Work carefully to prevent damage to the gearcasc seal surface. c. Drive or press out the bearing. Force the bearing to- ward the inside of the gcarcase. d. Clean the seal and bearing recesses in the cover with solvent and blow them dry with compressed air. e. Drive or press in a new bearing until the bearing scats in the recess in the gearcase. g. Position a new seal in the cover recess with its open end facing the inside of the gearcase. Drive the seal into place with a suitably sized seal driver or socket. f. App ly gasket sealer to the periphery of the seal. 1.
Disconnect the negative battery cable from the nega- tive battery terminal. 2. Remove the alternator as described in Chapter Nine. h. Refer to Chapter Seven and reinstall the governor shaft. 14. Reverse the removal procedure to reinstall the timing gearcase. Refer to Table 4 for the tightening torque of the gearcase retaining screws. 3. Remove the oil filter. 4. Detach the control cables from the speed control lever and the stop lever.