Yanmar — Yanmar Diesel Inboard Shop Manual for One, Two, and Three Cylinder Engines

118 CHAPTER SIX Second ring Top ring I ~> -:Oil control Ii ring Cam shaft gear 5. Position the piston so the numbered side of the rod (F ig ure 41) is toward the camshaft side of the engine. In- sert the piston/connecting rod assembly into the cylinder (Figu re 44). Lightly tap on the piston crown with a wooden hammer handle to insert the piston. Make sure the rod does not bang against the crankshaft. 6. Clean the connecting rod bearings carefully, includi ng the back sides. Coat the crankpin journal and bearings with clean engine oil. Place the bearings in the connecting rod and cap. 7. Pull the connect ing rod and bearing into position against the cran kpin.

Lightly lubricate the connecting rod bolt threads with engine oil. Oil pump gear Fuel injection dri ve cam Crankshaft gear Governor flyweight 8. Install the connecting rod cap. Make sure the rod and cap are properly aligned. Install the cap bolts finger-t ight. 9. Tighten the cap retaining bolts to speci fication (Ta ble 4). 10. Check the connec ting rod side clearance as described under Piston/Connecting Rod Removal in this chapter. TIMING GEARCAS E The timing gearcase covers the camshaft and crankshaft gears and the oil pump (Figure 45). The timing gearcase also conta ins the governor mechanism and serves as the mounting location for the fuel injection pump.

A ball bearing in the timing gearcase supports the outer end of the crankshaft. To remove and reinstall the timing gcarcasc. proceed as follows: