MULTICYLINDER ENGINES 117 0 11 ring-- {f g.p Expan sion ring gap 6 ~~~~~6/ ~~ _ Plastlgage .... . ;.~ Scale 3. Tighten the connecting rod cap to specification (T able 4). Do not rotate the crankshaft while the Plastigage is in place . 4. Remove the connecting rod cap. To determine bearing clearance, compare the width of the flattened Plastigage to the markings on the enve lope (Fig ure 42). If the clear- ance is excessive, have the crankshaft reground and install undersize bearings. Connecting Rod Bearing Clearance Measurement Pisto n/Connecting Rod Insta llation I. Rotate the crankshaft so the crankpin is at bottom dead center. 2.
Make sure the ring gaps are positioned as shown in F igure 43. 3. Immerse the entire piston in clean engine oil. Coat the cylinder wall with oil. 4. Install a piston ring compressor on the piston around the piston rings. I. Place the connecting rod and upper bearing half on the connecting rod journal. 2. Cut a piece ofPlastigage the width of the bearing (Fig- ure 40). Place the Plastigage on the journal, then install the rod cap and bearing. Be sure to install the cap so the marks on the cap and rod are on the same side (Figure 41). NOTE Do not place Plastigage over the journal oil hole. CAUTION Use extreme care in Step 5 to prevent the connecting rod from nicking the crankshaft journal.