116 CHAPTER SIX t 2. Measure the ring gap with a feeler gauge as shown in Figure 35. Compare the measurement with specifications in Tables 1-3. If the measurement is not within specifica- tion, the rings must be replaced as a set. Check the gap of new rings as well. If the gap is too small, file the ends of the ring to correct it (Figure 36). 3. Check the side clearance of the rings as shown in Fig- ure 37. Place the feeler gauge alongside the ring all the way into the groove. If the measurement is not within specifications (Tables 1-3), either the rings or the ring grooves are worn. Inspect and replace them as required. - .. 4.
Using a ring expander tool (Figure 38), carefully in- stall the oil control ring, then the compression rings. The oil ring consists of two pieces, the outer ring and the inner expansion spring. Assemble the oil ring on the piston so the expansion spring gap is on the opposite side of the pis- ton from the ring end gap. See Figure 39. The second compression ring is tapered while the top compression ring has a barrel face. The top of each compression ring is marked and must face toward the piston crown. Connecting Rod Inspection Have the connecting rod checked for straightness by a dealer or machine shop. The piston pin end of the connecting rod is equipped with a bushing.
Refer to Tables 1-3 for bushing specifica- tions. Ifbushing replacement is required, a press is neces- sary to remove the old bushing and install a new bushing. The oil holes in the bushing and connecting rod must align. Ream the bushing to obtain the desired clearance in Tables 1-3.