MULTICYLINDER ENGINES 115 Cylinder block 8uface o Bore gauge 2. Measure the cylinder bore diameter at several points with a bore gauge (Figure 32, typical). Figure 33 shows the points of normal cylinder wear. If dimension A ex- ceeds dimension B by more than 0.02 rom (0.0008 in.), rebore the cylinderand install a new piston/ring assembly. 3. If the cylinder bore is damaged or excessively worn, rebore the cylinder bore and install a new piston. If the piston is worn, but the cylinder bore is good, install a new piston. NOTE Obtain the new piston and have it available so the machine shop can bore the cylinder to the correct oversize dimension. @ P" """-A--44 Piston Ring FitlInstaUation 41n.
1 1. Check the ring gap of each piston ring. Todo this, posi- tion the ring at the bottom of the ring travel area and square it by tapping gently with an inverted piston. See Figure 34. B NOTE If the cylinder has not been rebored, check the gap at the bottom of the ring travel, where the cylinder is least worn. -- ~--- ---------