114 CHAPTER SIX I ----~--,.---- 1 ----1- J---- I I I I I I Piston rings Piston Pin Removal/Installation The steel piston pin rides directly in the piston and in a bushing in the connecting rod. Circlips at each end retain the piston pin in the piston. 1. Before removing the piston, place the crankshaft end of the connecting rod in a vise with soft jaws. Rock the piston as shown in Figure 29. Any rocking motion (do not confuse with the normal sliding motion) indicates wear on the piston pin, piston pin bore or connecting rod small end bore (or combination of these). 2. Remove the clip from each side of the piston pin bore (Figure 30) with a small screwdriver or scribe.
Hold a thumb over one edge of the clip when removing it to pre- vent the clip from springing out. 3. Use a wooden dowel or suitable tool and push out the piston pin. If the pin is difficult to remove, heat the piston with a hair dryer. Separate the piston from the connecting rod. Connecting rod Rod cap Piston/Cylinder Bore Check Unless precision measuring equipment is available, have this procedure done by a machine shop. 1. Measure the piston diameter with a micrometer (Fig- ure 31) at a right angle to the piston pin bore 9 mm (0.35 in.) from the bottom of the piston skirt. Bolts