MULTICYLINDER ENGINES 125 - 6 @ Sis;,> (,,, r>. 11. Carefully lift the crankshaft out of the eng ine (F igure 65). 12. Proceed as follows to replace the crankshaft seal in the main bearing housing: a. Pry the old seal from the main bearing hous ing with a large screwdriver. Work carefully to prevent dam- age to the main bearing housing seal surface. b. Clean the seal recess in the housing with solvent and blow it dry with compressed air. c. Apply gasket sealer to the periphery of the seal. d. Position the new seal in the housing recess with its open end facing the inside of the bearing housing. Drive the seal into place with a suitably sized seal driver. 13.
Refer to the Main Bearings section for information concerning service to the main bearings and thrust bear- ings. 14. Reinstall the crankshaft by reversing the removal procedure while noting the followi ng: a. Thoroughly lubricate the main bearings and thrust bearings. b. Be sure to install a new O-ring on the main bearing housing. c. Tighten the main bearing and intermediate housing bolts to the tightening torque specified in Table 4. After tightening, rotate the crankshaft to be sure it rotates freely. If not, loosen, then retighten the inter- mediate main bearing housing bolts.