126 CHAPTER SIX Camshaft gear d. Install a dial indicator as shown in Figure 63 and measure crankshaft end play. Compare the mea- surement with the specification in Tables 1-3. If end play is incorrect, refer to the Main Bearings section to determine the cause. e. Align the timing marks (Figure 66) on the camshaft and crankshaft gears when installing the crankshaft gear. f. Check timing gear backlash by installing a dial indi- cator as shown in Figure 67 or by rotating the gear teeth with soft solder between the gear teeth. Com- pare the measurement with the specification in Ta- bles 1-3. If gear backlash is incorrect, replace the camshaft and crankshaft gears. Inspection MAIN BEARINGS 1.
Clean the crankshaft thoroughly with solvent. Blow out the oil passages with compressed air. 2. Check the main and connecting rod journals for wear, scratches, grooves, scoring or cracks. Check oil seal sur- face for burrs, nicks or other sharp edges that might dam- age a seal during installation. The crankshaft is supported at each end by insert-type main bearings. The front main bearing is located in the crankcase and the rear main bearing is located in the re- movable main bearing carrier. The intermediate, in- sert-type bearing is held in a removable bearing housing. See Figure 61.
Two intermediate bearings are used on three-cylinder engines, while one intermediate bearing is used on two-cylinder engines. Crankshaft thrust (end play) is controlled by the inter- mediate bearing on two-cylinder engines. On three-cylinder engines, the intermediate bearing nearest the flywheel controls crankshaft thrust. Remove the crankshaft as described in the previous sec- tion for access to the main bearings. Unless precision NOTE Unless precision measuring equipment is available, have a machine shop perform Step 3. 3. Check all journals against specifications (Tables 1-3) for out-of-roundness and taper. Have the crankshaft reground, if necessary, and install new undersize bearings.