Yanmar — Yanmar Diesel Inboard Shop Manual for One, Two, and Three Cylinder Engines

MUL TIC YLIN DER ENG INES 127 8 A 6 Inter-mediate 'l ain Bearing I. Remove the intermediate bearing housing bolts (Fi~­ ure 68). 2. Separate the intermediate bearing housing halves from the crank shaft. 3. Inspect the bearings for excessive wear and damage. 4. Reassemble the intermediate bearing housing includ- ing the bearing inse rt s. Asse mble the bearing housing so the arrows (A. Figure 69) at the parting surfaces are on the same side. Tighten the bolts to the torque specified in Table 2. 5. Measure the crankshaft and bearing diameters and compare them with the specifications in Tab les 1-3. 6.

Measure the width of the intermediate thrust bearing (Fig ure 70) and compare itwith the specification in Tab le I. 7. Be sure to lubricate the bearing inserts with oil before installing the intermediate main bearing housing on the crankshaft. Install the bearing housing on the crankshaft so the F mark (B, Fi gur e 69) on the housing faces toward the flywheel end of the crankshaft. 8. Tighten the bearing housing bolts to the torque spcci- fied in Table 4. Width C":\ ISIiAfT Removal and Installation measuring equipment is available. have a dealership or machine shop measure main bearing dimensions. R ef er to specifications in Tables 1-3. I. Remove thc fuel transfer pump (Figure 71, typical).

2. Remove the crankshaft as previously described. 3. Prevent rotation of the camshaft gear by holding a screwdriver or other tool against the camshaft bearing rc- taining screw (Figure 72. typical). 4. Remove the camshaft gear nut (Fi~ ure 73), fuel injec- tion pump cam and camshaft gear. If front or rear bearing rep lacement is necessary. have the main bearings replaced by a dealership or machine shop. Be sure the oil holes in the main bearings ali gn with the oil passages in the cra nkcase and main bearing carrier.