130 CHAPTE R SIX Bore gauge Prol l1J slon ~F-" i c;:: ~ ~ Cylinder block ~ E:: ~ ~ V ~ block surface. When the cylinder head is installed, the clamping force of the head against the liner protrusion se- cures the liner in place. The protrusion also establishes a gas-tight seal between the liner and the head gasket. In- spect the liners as follows: Cylinder lin er NOTE The liner is a close fi t in the block, but it may be movable. Distortion or corrosion may freeze the liner in the block, which will ne- cessitate a puller to remove the liner: 1. Measure liner protrusion above the cylinder block (Figure SO)and compare the result with the specification in Tab les 1-3. a.
Excess protrusion may damage the head gasket. Ex- cess protrusion may be caused by improper seating of the liner flange in the block . possibly due to cor- rosion. b. Insufficient protrusion may allow compression leaks and liner movement in the block. Insufficient protrusion may be due to a worn liner or cylinder block. 2. Measure the cylinder liner bore at several locations to determine if the liner is out -of -round or distorted. Com- pare measurements with the specification in Tables 1-3. Replace the liner if the measurements exceed the specifi- cation. 3. Inspect the liner bore. Replace the liner if it is rusty. corroded or otherwise damaged. Straightedge