Yanmar — Yanmar Diesel Inboard Shop Manual for One, Two, and Three Cylinder Engines

MULTICYLINDER ENGINES 131 Cylinder block Sealing edge before Installation Strike here Wlthh7 Core plug Installation tool Removal and Installation CAUTION Do not drive core plugs into the engine cast- ing. It will be impossible to retrieve them and they can restrict coolant circulation, re- sulting in serious engine damage. 1. Tap the bottom edge of the core plug with a hammer and drift. Use several sharp blows to push the bottom of the plug inward, tilting the top out (Figure 81). 2. Grip the top of the plug firmly with pliers. Pull the plug from its bore (Figure 82) and discard.

Remove plug NOTE It is also possible to remove core plugs by drilling a hole in the center of the plug and prying it out with an appropriate size drift or pin punch. When removing a large core plug, the use of a universal impact slide hammer is recommended. Core Plug Replacement Check the condition of all core plugs in the block when- ever the engine is out of the boat for service. If any signs of leakage or corrosion are found around one core plug, replace them all. Core plugs in the cylinder block prevent damage to the block should the coolant freeze. The cylin- der block of 2GM, 3GM and 3HM engines is equipped with cast iron, removable cylinder liners. See Cylinder Liners in this chapter.

3. Clean the plug bore thoroughly to remove all traces of the old sealer. Inspect the bore for any damage that might interfere with proper sealing of the new plug. 4. Coat the inside diameter of the plug bore and the outer diameter of the new plug with sealer. Use an oil-resistant sealer if the plug is to be installed in an oil gallery or a wa- ter-resistant sealer for plugs installed in the water jacket. 5. Install the new core plug with an appropriate size core plug installation tool (Figure 83), driver or socket. Posi- tion the outside edge of the plug 2-3 mm (0.08-0.12 in.) inside the block. 6. Repeat Steps 1-5to replace each remaining core plug.

NOTE A machine shop can replace core plugs in- expensively. If machine work on the engine is necessary, have the core plugs replacedat the same time.