Yanmar — Yanmar Diesel Inboard Shop Manual for One, Two, and Three Cylinder Engines

144 CHAPTER SEVEN 12 Inj ection timin g shims 5. Loosen the fitting nut (Figure 12) on the injcctor(s) just enough to expel fuel. 6. Move the engine speed control to the full throttle posi- tion. 7. Move the decompression lever to the ON position. '-\\!;Z;if:='-- - - Plunge r r oll er '1- - - Fuel inje cti on cam NOTE Do not operate the starter for more than 30 seconds; otherwise tile starter may be dam- aged due to overheating. 8. Operate the starter until air-free fuel flows from the in- jcctorfs). 9. Tighten the injector fuel line fitting nutfs) to 20 Nom (15 ft.-lb.). 10. Operate the starter and listen for the distinctive noise that indicates the injector is operating.

FUEL INJECTION TIM ING Similar to ignition timing on a gasoline engine, the fuel must be injected at the proper time to obtain optimum combustion, Injection timing is determined by the relationship be- tween the injection pump plunger and the injection cam- shaft in the engine. The rotating cam acts against the roller on the pump plunger in the fuel injection pump (Figure 13) to force up the plunger and pump fuel to the injector nozzle. Moving the fuel injection pump up or down on its mounting surface changes the point on the cam that the plunger begins vertical movement, thereby changing when injection occurs.

Shims between the injection pump and its mounting surface on the engine are used to adjust fuel injection tim- ing (Figure 13). Increasing shim thickness retards injec- tion timing, while decreasing shim thickness advances injection timing.